簡易檢索 / 詳目顯示

研究生: 蔡坤霖
Kuen. Lin. Tsai
論文名稱: 高溫超導表面線圈於磁振造影中之特性與研究
High-Temperature Superconducting Receiver Coils for Magnetic Resonance Imaging
指導教授: 楊鴻昌
Yang, Hong-Chang
學位類別: 碩士
Master
系所名稱: 光電工程研究所
Graduate Institute of Electro-Optical Engineering
論文出版年: 2006
畢業學年度: 94
語文別: 中文
論文頁數: 57
中文關鍵詞: 表面線圈
英文關鍵詞: Receiver Coils
論文種類: 學術論文
相關次數: 點閱:128下載:0
分享至:
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報
  • 高溫超導表面線圈是為了增加核磁共振造影的敏感度而設計出來的,由螺旋形的釔鋇銅氧薄膜共振器以及2×2 cm2 的鋁酸鑭基座所構成。
    為使質子在3 Tesla下有更好的造影效果,並求知敏感度的差異性,我們使用釔鋇銅氧薄膜為共振器,比較高溫超導薄膜共振器與傳統銅電路板共振器,高溫超導薄膜共振器的訊雜比有顯著的提高,在128×128像素,金桔與斑馬魚的訊雜比增益分別為3.46與2.8倍,我們也將此結果與理論預估值討論與比較。
    此外我們以玻璃纖維材質(G10),針對3 Tesla磁振造影系統設計製作了一個低溫恆溫器(Dewar)量測架構並且使用了商業化的高溫超導帶材來製作直徑20 cm的超導帶表面線圈。以葡萄柚為待測樣品,造影像素為128×128,常溫下的銅表面線圈與77 K下的超導帶表面線圈,得到的訊雜比增益為2.8倍。葡萄柚為待測樣品,造影像素為512×512,常溫下的銀帶表面線圈與77 K下的超導帶表面線圈,我們得到訊雜比增益為2.17倍

    The HTS superconducting surface receiver coil composed a spiral YBa2Cu3O7-y thin film resonator on a 2×2 cm2 LaAlO3 substrate is designed to enhance the sensitivity of the nuclear magnetic resonance imager.
    For better performance YBCO resonator is optimized to the resonance imager frequency of the proton at 3 Tesla. To evaluate the sensitivity, the spin echo images coupled to the HTS resonator is presented and compared with images obtained from the copper surface resonator fabricated from the printed circuit board. An improvement of the signal-to-noise (SNR) ratio was achieved for YBCO thin film resonator over a conventional copper resonator. The SNR gain was 3.46 and 2.8 for calamondin and zebra fish at 128×128 pixels respectively. These results are discussed and compared with the theoretical calculation in the gain of SNR ratio.
    We designed a G10 glass fiber cryostat to be fit in Brüker 3T MRI system and used commercialized Bi2Sr2Ca2Cu3O tape to fabricate a HTS coil with a diameter of 20 cm . A SNR gain about 2.8 can be obtained from the HTS tape coil over a conventional copper surface coil in grapefruit at 128×128 pixels. A SNR gain about 2.17 can be obtained from the HTS tape coil over a silver surface coil in grapefruit at 512×512 pixels.

    封面內頁 1 致謝 3 Abstract 5 摘要 6 第一章 緒論 7 1.1 高溫超導表面線圈研究動機 7 1.2 高溫超導表面線圈發展簡介 8 第二章 磁振造影系統訊雜比與耦合線圈之原理 10 2.1 磁振造影系統之訊雜比 10 2.2 耦合線圈之設計 12 第三章 高溫超導薄膜表面線圈之設計與製作 14 3.1 簡介 14 3.2 製作流程與量測架構 15 3.2.1 材料 15 3.2.2 製作流程 17 3.2.2.1 超導薄膜的製作 17 3.2.2.2 超導薄膜的微影蝕刻 20 3.2.3 量測架構 26 3.3 結果與討論 31 第四章 高溫超導帶表面線圈之設計與製作 41 4.1 簡介 41 4.2 材料及製作流程 42 4.3 量測架構 44 4.4 結果與討論 47 第五章 結果與討論 53 5.1 結果 53 5.2 討論 54 參考資料 56

    [1]H. K. Onnes “The Resistance of Pure Mecury at Heliu Temperatures” Leiden Comm.120b(1911).

    [2]M. K. Wu,J. R. Ashburn, C. J. Trong,P. H. Hor,R. L. Gao, Z. J. Huang, Y. Q. Wang, and C. W. Chu.Phys. Rev. B35,5335(1987).

    [3]R. D. Black, T. A. Early, P. B. Roemer,O. M. Mueller, A. Mogro-Campero,L. G. Turner, and G. A. Johnson. “A High-Temperature superconducting receiver for nuclear magnetic resonance microscopy” Science, 1993.

    [4]J. R. Miller,S. E. Hurlston,Q. Y. Ma, D. W. Face,D. J. Kountz, J. R. MacFall,L. W. Hedlund, and G. A. Johnson.” Performance of a High-Temperature superconducting probe for in vivo microscopy at 2.0 T” Mag. Reson. Med.41,72–79(1999).

    [5] M. C. Cheng, K. H. Lee, K. C. Chan, K. K. Wong, and E. S. Yang. “HTS Tape RF coil for low field MRI”. Proc. Intl. Soc. Mag. Reson. Med.11,2359(2003).

    [6] H. L. Lee , “Tape and Thin-Film High-Temperature Superconducting RF Coils for 3T MRI” Master’s thesis, National Taiwan University(2004).

    [7] I. T. Lin, “The Design and Application of Bi-2223 High-Temperature Superconducting Tape RF Coil” Master’s thesis, National Taiwan University(2005).

    [8] D. I. Hoult and P. C. Lauterbur. “ The sensitivity of the zeugmatographic experiment involving human samples” J. Magn. Reson.34,425–433(1979).

    [9]J. Wosik ,L. M. Xie,K. Nesteruk,L. Xue,J. A. Bamkson,and J. D. Hazle.“ Superconducting single and phased-array probs for clinical and research” MRI IEEE Trans. Appl.Supercon.13(2),1050-1055(2003).

    [10] D. Kajfez and E. J. Hawn. “ Q-factor measurement with network analyzer” IEEE Trans. Microwave Theory Tech.MTT-32(7),666–670(1984)

    [11]D. I. Hoult and B. Tomanek. “Use of mutually inductive coupling in prob design”Con.Mag.Reson3.15(4),262-285(2002).

    [12]Jr. W. H. Hayt. Engineering Electromagnetics. McGraw-hill,4th edition(1981)

    [13]B. Raveau, C. Michel, M. Hervieu, and D. Groult. “Crystal
    Chemistry of High-Temperature Superconducting Copper
    Oxide” Springer-Verlag(1991).

    [14] N. G. Chew, S. W. Goodyear, J. A. Edwards, J. S. Satchell, S. E. Blenkinsop and R. G. Humphreys. “Effect of small changes in composition on the electrical and structural properties of YBCO thin films” Appl. Phys. Lett. 57,2016–2018(1990).

    [15] W. R. Smythe. “Static and Dynamic Electricity” Hemisphere(New York),3rd edition(1989).

    [16] J. Yuan and G. X. Shen. “Quality factor of Bi2223 High-Temperature superconductor tape coils at radio frequency” Supercon” Sci. Tech.17,333–336(2004).

    [17] M. Quilitz and W. Goldacker. “Oxygen exchange in Bi(2223) tapes with Ag and alloyed agmg sheaths monitored by a thermogravimetrical relaxation method” Supercon. Sci. Tech. 11(6),577–583(1998).

    無法下載圖示 本全文未授權公開
    QR CODE